10-Watt Solar Street Light

At its 1,700-lumen high setting, the SSL-10 is intended for localized outdoor illumination rather than broad, high-output area lighting. It can be a practical fit for entrances, driveways, courtyards and other defined zones where the light can be positioned close to the area being illuminated.

Lumens describe total light output, not how much light ultimately reaches a particular point on the ground. Mounting height, beam distribution, distance, surrounding surfaces and obstructions all affect the result.

Coverage depends on mounting height and the surface being illuminated. At around a 10 ft mounting height, a practical reference is roughly 10–12 ft of illuminated width, but the useful area will vary with site conditions and the brightness level you expect.

For a parking area, plan around the actual space rather than assuming that one fixture will evenly illuminate an entire lot.

Recommended mounting height is approximately 6–13 ft (2–4 m). Mounting higher increases the area reached by the light but generally reduces the intensity perceived on the ground, while mounting lower concentrates the light over a smaller area.

For installations using multiple fixtures, spacing, mounting height and the geometry of the site should be considered together.

The SSL-10 is designed to remain illuminated after dark rather than staying off until someone approaches. Motion detection temporarily increases the light output, then the fixture returns to its lower nighttime level after activity has passed.

This gives you continuous nighttime visibility together with additional brightness when a person or vehicle enters the sensor range.

Yes, but cloudy conditions reduce the amount of solar energy available for recharging. After a full charge, expected nighttime runtime is approximately 8–12 hours, while repeated low-sun days can progressively reduce the available operating time.

One to two days without strong direct sun may still be possible under favorable conditions, but consecutive cloudy days, winter sun angles, shade and frequent motion activation can shorten runtime.

Yes. The SSL-10 can be installed on a suitable wall or pole, so it is not limited to a dedicated street-light pole. This can be useful beside a building, driveway, courtyard or entrance where a structurally sound mounting surface is already available.

For pole installation, confirm the diameter and mounting hardware before ordering. The compatible mounting arrangement can accommodate round or square poles up to approximately 3.25 inches.

The fixture does not need a connection to the electrical grid, so there is no normal requirement to trench a power cable from a building to the light. Installation instead centers on choosing a secure mounting point with adequate solar exposure.

A professional may still be appropriate when a new pole, structural mounting work or site-specific safety requirements are involved, but the light itself does not require mains electrical service.

It can be useful for localized commercial areas, entrances, smaller lots and supplementary lighting, but a single 10W fixture should not automatically be assumed to satisfy the lighting requirements of a full commercial parking lot. Larger sites may need higher-output fixtures, multiple poles or a professionally designed layout.

If a project has required minimum light levels, uniformity targets, security requirements or local-code obligations, those requirements should determine fixture selection and spacing.